Comments on: 91 Dodge Dynasty blower motor control switch?

By: paul h

paul h — Sun, 11 Jan 2009 18:24:59 +0000

Sometimes, the wiring has to be modified to make a replacement switch work....look at the old switch terminals compared to the new one and see if any of the old terminals share a common contact point. If so, you'll need to splice the wiring for those terminals. Just be sure anything you splice can be undone if it does not work out. Or try geting a switch from a dealer.
References :

By: Ron B

Ron B — Sun, 11 Jan 2009 18:15:59 +0000

Did the wiring harness connector have 6 wires. It may not have but 5. Switch manufacturers sometimes don't put all the pins in if they know that they are not needed in certain applications. Check the wiring connector and see if it has a wire in the spot where the replacement switch is missing a pin>
References :

By: UCANTCME

UCANTCME — Sun, 11 Jan 2009 17:49:59 +0000

TRY THIS GUY, I HAVE PURCHASED MANY ITEMS FROM HIM THROUGHOUT THE YEARS AND SOMETIMES HE HAS A LOT OF OLDER PARTS AND ODDBALL PARTS, ALSO HAS VERY GOOD PRICING AS WELL AND IS A VERY FAST SHIPPER.

http://WWW.TEXASERICK.COM
References :
923

By: IM

IM — Sun, 11 Jan 2009 17:19:59 +0000

try getting the other part or buy a used dodge take the part out and fix it if needed to be fixed
References :